I just bought a used 2002 Focus ZTS. After a couple of days, someone stopped me and said my brake lights are not working. After checking it out, my center brake light is working. It is the 2 on the sides that are not. I began reading online forums for help, I still have a couple of questions. Some people say it could be the GEM. Where is it Dash board light not working along with tail light. Sep 07, 2012 • 2006 Ford F-250 Super Duty. 3 helpful. 2. This problem is caused by one of the door ajar sensing switches being defective, it is a common fault in Many Ford cars and light trucks. Each door has a switch and two at the tail gate door. The switches are attached to the side of There are many reasons why a driver might need a new tail light assembly, but two of the most common causes are collision damage and dimming from expiring lightbulbs. No matter if only one of the lights in the fixture is not working correctly, the assembly needs to be examined and brought back to optimal condition. The tail light fuse in a 2012 Ford Fusion can be found in the fuse panel that is in the cabin on the driver's side under the steering wheel. The fuse should be number 22 but always check with the cover that is over the panel to confirm. If Your tail lights are out on Your Fusion the first thing You should check are the bulbs. Hey everyone. I have a 2006 Ford F250 6.0 Powerstroke and currently have no tail lights or license plate lights. I have brake lights, turn signals, back up lights, and even have trailer lights. I've checked all of my fuses with a volt meter multiple times and everything is reading 12 volts on both sides of the fuses. 2013 Focus Hatchback tail lights not working. I was trying to swap out the OEM tail lights to some aftermarket ones. And the aftermarket ones did not quite work after the swap. Everything works before I start up the car (engine on). However, the tail lights do not work after I start up the car. Reverse works, signal works, brake works, not the Posted May 18, 2010. The bad earth (if it is that) will be at the point common to the brake / tail lights to cause this problem, i.e at the bulb socket. If its not a bad earth the next likely suspect is one of the rear brake / tail bulbs itself, the filaments may have shorted. This version has limited support for the early Focus MK3.5. However after a short period Ford changed the hardware numbers of the MK3.5 IPC and BCM. These vehicles are not supported by the FoCCCus program. The Forscan program or the Ford IDS diagnostic system are much more suitible for the Focus MK3.5. 3. HOW TO REPLACE BRAKE LIGHT SWITCH ON FORDIf you have Ford and you need to replace brake lights switch we will show you how to do that in this video. Usually The most common reason why your tail lights are not working but brake lights are is due to a bad or wrong type of light bulb installed. It can also be caused by a blown fuse, bad wirings, or corroded sockets or plugs. A faulty control light switch could also be to blame. While these are not all of the possible causes, they are the most common ones. P4jrMf.